If the concrete mixing station uses a belt conveyor, install the belt conveyor first, install the idler group and the diverting roller in the frame, and install the belt. If there is no belt conveyor, use the aggregate lifting device , When installing the mixing host, it is relatively simple to install the hoist, the ladder track, etc.
The installation of the batching machine is carried out on the ground, sometimes the batching machine is elevated, and sometimes the batching machine is hidden on the surface, which has its advantages. Hang the pre-hanging screw of the weighing bucket on the lower part of the silo. After the aggregate silo is installed and positioned, adjust the screw at the hanging point of the weighing bucket to make the weighing bucket in a horizontal state, and then replace the sensor suspension device. When installing the concrete batching plant, the above assembly sequence must be followed, and one section must be installed, and the other section must be measured and tested.
If the concrete mixing station is used for a short period of time, and you do not want to fix the anchor bolts, lay wooden sleepers on the base and lay them flat to stabilize the batching machine better. The operating table should be suitable for our operators to see the working conditions of various parts, and the operating table should also be covered with rubber or dry wood.
The installation of each part of the concrete mixing plant requires professionals to carry out, and then debugging is required, so everyone must ask whether the manufacturer is responsible for the installation when purchasing a concrete mixing plant, otherwise it will bring trouble to the later use!
